{"id":1357,"date":"2014-02-26T00:35:27","date_gmt":"2014-02-25T23:35:27","guid":{"rendered":"http:\/\/www.sciencetronics.com\/greenphotons\/?p=1357"},"modified":"2025-06-16T18:38:09","modified_gmt":"2025-06-16T16:38:09","slug":"led-lamps-are-not-forever","status":"publish","type":"post","link":"https:\/\/www.sciencetronics.com\/greenphotons\/?p=1357","title":{"rendered":"LED lamps are (not) forever"},"content":{"rendered":"

Two weeks ago I wrote about my experience with special price offers for LED bulbs at Bauhaus<\/a>. What I didn’t write was that I then just went to the other side of the street – well almost – and bought a 2.2 W E14 LED bulb at Jula<\/a>.<\/p>\n

\"2.2<\/a>
2.2 W E14 LED light bulb from Anslut.<\/figcaption><\/figure>\n

Why – well I have six of these lighting up my bookshelves. Originally I used CFLs for many years, but when these gave up one after the other I finally changed to LEDs. And there were these nice looking 2.2 W bulbs with a very nice light for a good price at Jula. I didn’t write it down, but I think it cannot have been more than three years ago when I put in the first of the LEDs. <\/p>\n

And now – two weeks ago – the first of those gave up. And just a week later followed number two!<\/p>\n

This inspired me to do some forensic research on the two broken LED bulbs. Clearly they could not possibly have passed the 25000 hours or 20000 times of switching, which “manufacturer” Anslut states on the back of the blister package – I estimate the lights to be on for less than 5 hours every day, which after 3 years would add up to just about 5500 hours and switching them on twice a day (morning and evening) adds up to less than 2200 cycles.<\/p>\n

So? What’s wrong then?<\/p>\n

Well it might be the quality – or rather the lack of such – in these particular LED lights!<\/p>\n

In order to do forensic research I of course had to disassemble the LEDs <\/a>.<\/p>\n

\"Two<\/a>
Two broken 2.2W LED light bulbs after removing the glass dome. Notice the yellow discoloring on the left one – something must have gotten warm here…<\/figcaption><\/figure>\n
\"Do<\/a>
Do you see the black spot? In each of the PLCC 5050-LEDs there are 3 individual LED chips. The black spot is exactly on top of one of these…<\/figcaption><\/figure>\n
\"Same<\/a>
Same for the second bulb: Do you see the black spot?<\/figcaption><\/figure>\n
\"Breaking<\/a>
Breaking open the socket reveals – well not much…<\/figcaption><\/figure>\n
\"Desoldering<\/a>
Desoldering the top layer LED board reveals a quite dark capacitor.<\/figcaption><\/figure>\n
<\/a>
Almost like a hidden art sculpture a foil capacitor sits on top of an electrolytic capacitor.<\/figcaption><\/figure>\n
\"After<\/a>
After removing all LED boards the driving circuit is in front of you.<\/figcaption><\/figure>\n
\"And<\/a>
And these are the 7 LED boards.<\/figcaption><\/figure>\n

\"One<\/a>
One of the 2-LED boards from the front…<\/figcaption><\/figure>
\n
\"and<\/a>
and the same 2-LED board from the back.<\/figcaption><\/figure>
\nThe LEDs are mounted on individual circuit boards carrying 2 and 5 LEDs of the PLCC 5050 type. Each package contains 3 individual LED chips with individual contacts on the sides of the package. Looking at the conductor pattern which is visible from the backside through the circuit board material, you can see that all LEDs on a board are connected in series. Going further you will find that also all boards are connected in series, which shows the construction of the lamp to be a single string of 51 individual LED chips.<\/p>\n

\"The<\/a>
The top board with 5 LEDs from the front.<\/figcaption><\/figure>
\n
\"And<\/a>
And the same 5-LED board from the back.<\/figcaption><\/figure><\/p>\n


<\/p>\n

So what about the rest of the circuit – well it turns out that there is not that much, and that bit there is, is actually a bit frightening. No, I don’t believe that these LED bulbs are a danger for your health, but they must have been engineered by a couple of blind monkeys<\/em>.<\/p>\n

\"Circuit<\/a>
Circuit diagram over the 2.2 W LED light bulb.<\/figcaption><\/figure>\n

The circuit is a capacitor-coupled full-wave rectifier – nothing special so far, we have seen this in LED Christmas lights<\/a> before. The utility companies might not be too happy about it, since the power factor of these circuits are really bad – but this is not the weakest point of this circuit. The mains capacitor was the darkened foil capacitor from above. The text on the package was almost undecipherable, but it reads 390nF\/400V – no X or Y marking though! The capacitor is bypassed by a 470 kΩ SMD resistor – at least you will not get shocked from any remaining charge on this capacitor.<\/p>\n

But then there is also a through-the-hole mounted 1 Ω resistor in series with one of the AC connectors. What is this resistor for? With its low value it can hardly limit any inrush current, is it a replacement for a more expensive fuse? <\/p>\n

On the secondary side of the bridge rectifier there we find our friend from above, the electrolytic capacitor 4.7 \u00b5F\/400V. We also see a 470 Ω resistor in series with the string of 51 LEDs – wait a second, 470 Ω? For what, assuming an LED current of 20 mA, this resistor will not add any reasonable amount of current limit on a string of 51 white LEDs!<\/p>\n

I checked both capacitors: they both showed still their nominal value. Before that measurement I suspected that the 390 nF foil capacitor might have failed short and thus overloaded the LED string – I still cannot completely rule this out, since the surge of current might have immediately taken out the short again. I even unwrapped most of the capacitor’s foil, but didn’t find any bigger suspicious spot.<\/p>\n

Measuring the characteristics of the LEDs made it possible to get a decent simulation of the circuit.<\/p>\n

\"Current-voltage<\/a>
Current-voltage characteristic of a single one of the 51 LEDs in the string.<\/figcaption><\/figure>\n
\"Ltspice<\/a>
Ltspice simulation of the circuit. The second panel from the top shows the voltage and current waveforms on the input side, the lowest panel shows the current through the LEDs.<\/figcaption><\/figure>\n

From these simulations one can see that the 4,7 \u00b5F capacitor on the DC side of the rectifier bridge is much too small to smoothen out the current through the LEDs – even if not disturbingly noticeable these LED light bulbs do flicker with twice the mains frequency, i.e. 100 Hz here in Europe.<\/p>\n

Finally: yes I replaced both broken light bulbs with exactly the same type again. After all, they were on sale for just 29:- SEK (about 4.50 USD) – and they are most probably still much more reliable than the direct imports from China you can get on eBay. But quality does look differently as can be seen in other LED light bulbs I have disassembled over the year.<\/p>\n","protected":false},"excerpt":{"rendered":"

Two weeks ago I wrote about my experience with special price offers for LED bulbs at Bauhaus. What I didn’t write was that I then just went to the other side of the street – well almost – and bought a 2.2 W E14 LED bulb at Jula. Why – well I have six of […]<\/p>\n","protected":false},"author":1,"featured_media":1342,"comment_status":"open","ping_status":"open","sticky":false,"template":"","format":"standard","meta":{"jetpack_post_was_ever_published":false,"_jetpack_newsletter_access":"","_jetpack_dont_email_post_to_subs":false,"_jetpack_newsletter_tier_id":0,"_jetpack_memberships_contains_paywalled_content":false,"_jetpack_memberships_contains_paid_content":false,"footnotes":"","jetpack_publicize_message":"","jetpack_publicize_feature_enabled":true,"jetpack_social_post_already_shared":true,"jetpack_social_options":{"image_generator_settings":{"template":"highway","default_image_id":0,"enabled":false},"version":2}},"categories":[11,8,40],"tags":[42,43,44],"class_list":["post-1357","post","type-post","status-publish","format-standard","has-post-thumbnail","hentry","category-electronics_en","category-everything_en","category-leds","tag-anslut","tag-jula","tag-led","entry","has-media"],"jetpack_publicize_connections":[],"jetpack_featured_media_url":"https:\/\/www.sciencetronics.com\/greenphotons\/wp-content\/uploads\/2014\/02\/IGP9525a_600.jpg","jetpack_shortlink":"https:\/\/wp.me\/p48grL-lT","jetpack_sharing_enabled":true,"_links":{"self":[{"href":"https:\/\/www.sciencetronics.com\/greenphotons\/index.php?rest_route=\/wp\/v2\/posts\/1357","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/www.sciencetronics.com\/greenphotons\/index.php?rest_route=\/wp\/v2\/posts"}],"about":[{"href":"https:\/\/www.sciencetronics.com\/greenphotons\/index.php?rest_route=\/wp\/v2\/types\/post"}],"author":[{"embeddable":true,"href":"https:\/\/www.sciencetronics.com\/greenphotons\/index.php?rest_route=\/wp\/v2\/users\/1"}],"replies":[{"embeddable":true,"href":"https:\/\/www.sciencetronics.com\/greenphotons\/index.php?rest_route=%2Fwp%2Fv2%2Fcomments&post=1357"}],"version-history":[{"count":28,"href":"https:\/\/www.sciencetronics.com\/greenphotons\/index.php?rest_route=\/wp\/v2\/posts\/1357\/revisions"}],"predecessor-version":[{"id":2435,"href":"https:\/\/www.sciencetronics.com\/greenphotons\/index.php?rest_route=\/wp\/v2\/posts\/1357\/revisions\/2435"}],"wp:featuredmedia":[{"embeddable":true,"href":"https:\/\/www.sciencetronics.com\/greenphotons\/index.php?rest_route=\/wp\/v2\/media\/1342"}],"wp:attachment":[{"href":"https:\/\/www.sciencetronics.com\/greenphotons\/index.php?rest_route=%2Fwp%2Fv2%2Fmedia&parent=1357"}],"wp:term":[{"taxonomy":"category","embeddable":true,"href":"https:\/\/www.sciencetronics.com\/greenphotons\/index.php?rest_route=%2Fwp%2Fv2%2Fcategories&post=1357"},{"taxonomy":"post_tag","embeddable":true,"href":"https:\/\/www.sciencetronics.com\/greenphotons\/index.php?rest_route=%2Fwp%2Fv2%2Ftags&post=1357"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}