Calendar

March 2024
M T W T F S S
 123
45678910
11121314151617
18192021222324
25262728293031

Categories

Active supporter of WikiPedia
Support Wikipedia

Geocaching

Profile for uwezi

Lights for Energihuset

Today I designed a solar-cell powered LED lighting for a model of the planned energy education centre Energihuset in Uppsala. The model was built by Nyréns Arkitektkontor and equipped with 108 white light-emitting diodes, series connected in groups of three for a common supply voltage of 12 V. The model will be presented at the Swedish Energiting in Stockholm.

The CIGS thin film solar-cell modules are designed to give a voltage which fits the maximum voltage of 5.5 V for backup-capacitors — a battery of these capacitors will be charged from the solar cells and then provide the power supply for the LEDs. I came up with the following circuit:

Solar cell powered LED light

The central part is a DC-DC converter around a MC34063. This integrated circuit compares the external voltage at its pin #5 with an internal reference voltage of 1.2 V in order to stabilize the output voltage. I connected a light-dependent resistor in parallel to one of the resistors in the voltage divider for this feedback voltage. In the dark the resistance of the LDR is above 300 k&Omega while sinking below 3 kΩ in ambient light conditions. In the circuit this results in an output voltage under illumination which lies below the LEDs’ threshold voltage. In the dark this voltage rises to between 8 V and 12 V, depending on the actual resistance of the LDR and the position of the variable resistor — and the LEDs will light up.

The efficiency of this circuit is certainly not the best. The MC34063 is a simple integrated circuit to work with but it also has a considerable consumption. Even the voltage divider should probably be built with higher resistances — in the current design it draws about 0.5 mA by itself. But the performance should be sufficient for the task at hand: charging a single 1 F capacitor from a 1 Wp solar cell module takes about 90 seconds under a poor halogen bulb and the discharge lets two strings of 3 LEDs each light for about 60 seconds.

The complete system

The circuit board

3 comments to Lights for Energihuset

  • After research a couple of of the weblog posts on your website now, and I really like your means of blogging. I bookmarked it to my bookmark web site listing and will probably be checking again soon. Pls check out my website as nicely and let me know what you think.

  • ekskluzywna bielizna nocna

    Hi, maybe this is not on topic but anyway, I have been browsing about your web site and it looks truly neat. impassioned about your writing. I’m building a new web log and hard put to make it appear great, and provide really good content. I have revealed a lot on your internet site and I look forward to more updates and will be coming back.

  • Thanks for sharing these useful information! Hope that you will continue doing nice article like this.

Leave a Reply to gry dla dzieci

 

 

 

You can use these HTML tags

<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>